3D-Printed Enclosure for Heltec V4 (GPS) Fixed with Power Switch
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A case for the Heltec V4 with GPS that I added a cutout for a small power switch to and replaced logos with Meshtastic.
- Ocena
- 5 / 5
- Polubienia
- 13
- Pobrania
- 88
- Wydruki
- 1
- Wyświetlenia
- 981
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I took the remix from Tom_Ash and added a cutout for a power switch to it because I prefer being able to completely turn off the node to conserve battery. I also added the Meshtastic logo to the front and back of the case.
Link for the power switch I used (5mm version): https://www.amazon.com/dp/B0DN67RV4W?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1
I added the switch between a male and female JST 1.25mm connector so that I didn't have to cut the battery wires and I can still remove it from the case if needed. The power switch is held in place with superglue. I also added a route for the wires along the bottom of the case so that they would not have to be run alongside the antenna coax to reduce any possible interference. I used 26 AWG wire and twisted them together.
Edit: Parker has created a base station for the model you can download here:
https://www.printables.com/model/1772630-heltec-v4-enclosure-dock