Spoolholder for Snapmaker U1 (no snap-in)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Another spoolholder alternative for the Snapmaker U1, but requires no snap-in.
- Ocena
- 5 / 5
- Polubienia
- 4
- Pobrania
- 24
- Wydruki
- 2
- Wyświetlenia
- 145
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
You also installed the original spoolholders and then found out they are "not good"?
Then you also struggled even more to remove them again, fearing to break the whole sidepanel of the printer?
You searched for alternatives, but they all use the same snap-in mechanism, where the snap-ins probably just break or snap in so hard, you can also barely remove them again?
Well here's a different solution. And it also allows to use small spools (like the 250g Jayo ones)
Step 1:
Put in the bottom part with the flat part vertically.
Step 2:
Rotate it by 90° so that the flat surface is on top.
Step 3:
Insert the top part.
Step 4:
Push it in and secure it with a screw (i used a small 2mm wood screw)
Pressing in the top part should fit really tight. If it is to hard to press in, just sand the flat part of top (and/or bottom) part a little bit until it fits.