Cosplay Mask, Hat and Wig Stand V2
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a Mask, Hat and Wig Stand. The design emphasis was minimalism and speed of printing. In this remix I have…
- Ocena
- 4,962 / 5
- Polubienia
- 297
- Pobrania
- 1815
- Wydruki
- 27
- Wyświetlenia
- 5031
- Oceny
- 26
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution
This is a Mask, Hat and Wig Stand. The design emphasis was minimalism and speed of printing.
In this remix I have separated the parts so that the thing can be printed on a 220 x 220 build plate at 100% or on a 200 x 200 build plate at 95%.
Conversely the V2 protoype was a little large for my Batman Cowl so therefore I probably should have reduced to 95%.
Parts are a reasonably tight interferance fit but can be glued for greater security.
Printing Instructions:
1.The things were printed fast using a 0.8mm nozzle, 0.6mm layer height and @40mms. 1 perimeter and 7% infill.
2.Further speed reductions may be achieved with only printing bottom layers and rely on the infill for rigidity. Average print time at these settings was approx. 35 minutes.
Category: Organization