1 / 2
Prusa Mk4 upgraded Spool Holder with 608 Bearings — zdjęcie 1
1 / 2

Prusa Mk4 upgraded Spool Holder with 608 Bearings

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Many 3D filament spool holders create too much drag/friction on the extruder motor. This creates less drag using 608's.

Ocena
0 / 5
Polubienia
4
Pobrania
12
Wydruki
0
Wyświetlenia
78
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

Created the parts, I used the simple Microsoft 3D Builder.  Printed all parts on my Mk4 printer.

Prusa's engineers who designed their spools need to go back to the drawing board and re-design the center, 51mm, slot.  The "speed bumps" within the interior of the center inhibit 608 bearings from creating a smooth spool rotation.  The sleeve I made is a tight fit, which I did intentionally so there's no need for glue.  The outer rings are for looks, but it also keeps the center sleeve in place.  Just dab a few drops around the outer perimeter of the center slot and place the both rings centered when gluing.

Print the spool arm just as it is for the best strength.  Add SUPPORTS (paint some support to the top of the two triangles which lock the spool arm into the center spool support.  I used 4 walls and 20% infill.  Use your own judgement for your print.

**** As for using 608 bearings.  Factory, commercial bearing centers fit the printable dowels I've included.  But, if you decide to print your own 608 bearings, keep in mind the center slot might be too tight and you'll have to sand down each dowel to slide the dowels in place.

From what I've searched for on the Internet, I feel my creation provides the best free-wheeling spool rotation of any other spool holder.

As for any other brand and model of 3D filament spools out there with the same configuration as Prusa's, you can use the sleeve I created and measure your brand's spool width and depth and in PrusaSlicer, adjust the X,Y and Z's to match your other spools (adjust the two end caps as well) and print.

**** UPDATE****  For those who are using WIDE spools, the included SLEEVE with prevent the spool from migrating off the spool holder.  The SLEEVE will reduce friction.  Spools don't have a smooth inner diameter, only the outer rim rests on the spool holder.  The 608 bearings don't do any good unless you slide this newly uploaded sleeve to totally reduce the friction.  Based on how smooth my spools turn now, I'd say this setup is probably the most efficient, friction-free way to print, as it reduces any chance of the extruder motor from over-working.

The added "spool holder end washer" does not need any glue, it makes a perfect, tight fit.  Besides, when inserting the spool holder in place, it locks itself in place.

Tagi