1 / 4
Replacement Viewfinder for Canon XL1/XL1S/XL2 Camcorders — zdjęcie 1
1 / 4

Replacement Viewfinder for Canon XL1/XL1S/XL2 Camcorders

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A replacement viewfinder for the Canon XL Camcorders that uses a tilting 3.5" LCD.

Ocena
0 / 5
Polubienia
0
Pobrania
7
Wydruki
0
Wyświetlenia
90
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Photo & Video
Licencja
Creative Commons — Public Domain

I designed a replacement viewfinder for the Canon XL1/XL1S/XL2 cameras. I didn't have an XL2 viewfinder, so I made one so I could shoot with it! I used the original mounting system so everything fits nicely.

Uses a generic 3.5" lcd off of amazon that snugly fits into a housing. The screen and pcb can press into place and secured using hot glue. The cord can be secured using hot glue too. The back of the housing press fits on too, you can use glue if you'd like. I may design a clip to keep the cord secured, but hot glue does the job just fine. The screen can be modified to use 5v if you remove a diode and solder a jumper wire. I modified mine to usb a so it can be powered off my camera battery that has usb out.

The screen screws on with a 1/4-20 .750" bolt. It can tilt, but not fold. I may redesign the mount to do this in the future. The mic holder uses a piece of filament for the hinge and is screwed down with a 10-24 bolt. Any screw that fits the hole will also work.

The mic holder holds the mic as is, but I left space to add tape or felt to dampen the microphone.

I printed using PLA at .16mm layer height. I used 3 walls and 20% infill, it doesnt need to be super strong. Be careful with the coldshoe on the top when removing supports.

LINK TO THE SCREEN ON AMAZON

https://a.co/d/02oT6LgL

Tagi