Homematic IP WTH2 Stand
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple one part stand for HMIP WTH2 temperature and humidity sensor and controller
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 25
- Wydruki
- 0
- Wyświetlenia
- 109
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Simple one part stand for HMIP WTH2 temperature and humidity sensor and controller.
There are few others available. This version stands out for flush alignment of the sensor with its frame. The wall-mounting plate with the two snap hooks fits perfectly and disappears in the system. For screws I took self-tapping screws with ø3x5 or 6mm and Tx10, Check the length before penetrating your nice print.
Tip: I cut off a few strips of white insulating tape, maybe 4mm wide and applied them to the sensor itself. This provides a better seat and no gap between sensor and wallframe. I cut off the length of two times the length of the sensor, so two strips around the sensor (180°) did one layer. I made 2 layers in total. Due to the 4mm width you really cannot see the tape. If not yoou'd see the gap. And when this is midaligned you can see it even more.
Easy to print. I took PETG, MK4 did the job in 90 minutes. Variable layerheight. No big deal.
Explore my other Printables: https://www.printables.com/de/@Tritschi