Heat insert soldering iron stand
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Heat insert soldering iron stand
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 62
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Attribution — Share Alike
Heatset brass insert stand for holding the soldering iron and making sure vertically it stays. I ordered wrongly 6mm linear rods and LM6UU bearings. So I modelled the stand to use the parts that would otherwise be gathering dust.
Everything I designed from ground up because all the heat insert stands use linear rails.
Every part has a M6 holes for mounting the nylon fishing line and spring, or rubber band or whatever elastic to have the tension controlled. Use the roller that
I have not yet printed it but because I will be building Voron 2.4 350 mm I will have to build it to make the heatset insert work easy. Intended material is PETG but any plastic will suffice.
The holes for rods should probably be cleared with a 6mm drill bit or press fit.
I have chamfered most of the parts as well as oriented the STL files for optimal printing. Use supports for overhanging parts where you are not sure about the hanging. Also added a pulley for optimal setup of the spring. Spring is to be done manually by hand using whatever spring wire you have.