Bike underseat Airtag holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Airtag holder for standard seat rail mounts
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 51
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Share Alike
We bought ebikes and wanted a bit more security for them. Airtag seemed to be the ideal answer. However finding a good place to hide it and not impair its range was an issue. Other airtag holders were set up for angled seat rails (as I have on my bike), but my wife's "comfy seat" has these parallel rails going up in back.
So this leads to this design which places the airtag between and behind the rails.
The hardware is M3, with the screws being 16mm long and having the low profile head. I was originally going to mount this reversed to hide the screws, but I don't think too many thieves will be carrying a 1mm allen wrench.
PLA is OK despite mild UV resistance. ASA would be an ideal choice but I only had grey which would have stood out. I use a soldering iron with a heat set insert tip to push the nuts in. This makes them stay in nice and tight.