Deckel und Spacer Netzteilplatine für / lid and spacer power board for EM4K/TM4K
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Required plastic parts to get rid of the stupid battery in the Tomlov TM4K / Elikliv EM4K microscope
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 2
- Wydruki
- 0
- Wyświetlenia
- 25
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
----for english, please scroll down----
Kunststoffteile für den Umbau des Tomlov TM4K / Elikliv EM4K auf ein anständiges Netzteil, sofern man den USB-Port nicht benötigt. Für Details siehe https://www.mechanotronikum.de/57309-elikliv-em4k-tomlov-tm4k-akku-loswerden.html
Hinweis: aus ausreichend temperaturbeständigem Material drucken - PLA könnte hier an seine Grenzen kommen, da der LM1084 bis zu 100°C warm werden kann.
---
Plastic parts to convert the Tomlov TM4K / Elikliv EM4K to a decent power supply if you do not need the USB port. For details (in german) see https://www.mechanotronikum.de/57309-elikliv-em4k-tomlov-tm4k-akku-loswerden.html
Remark: print from suffciently heat resistant material - PLA might reach its limits because the LM 1084 can reach up to 100°C.