Eureka Mignon Single Dose Output-Attachment
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Unlike the formerly provided Dosing Cup-Attachment, this Model stays on your Coffee Grinder.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 4
- Wydruki
- 0
- Wyświetlenia
- 73
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
When the ground coffee was blown out of the grinder, the finest coffee particles were distributed around the grinder. As a result, a fine film of coffee dust has formed on the work surface.
To avoid this, I designed an attachment (https://www.printables.com/model/816694-dosing-cup-attachment-for-eureka-mignon-single-dos) for the dosing cup supplied with the Eureka Mignon Single Dose.
In order to provide a solution, that is connected directly to the machine body and does not require removal after every single grind, I designed the current Output-Attachment.
In order to secure the Attachment to the machine, you need to exchange the original screw (which is a little bit to short) with a M4x16mm screw.
You will notice a little gap (ca. 1-1,5 mm) between the front of the Output-Attachment and the machine. This is on purpose - by adding a little foam rubber (Moosgummi) with a thickness of 2 mm, you can assure a tight fit of the Attachment to the machine. This shall reduce the amount of fine coffee dust blow out.
Since you don't want the coffee to sneak into the screw tunnel, I added a separate seal-knob.
If there is a need for customization, I will be happy to provide you with the Fusion-file on request.