1 / 3
Thule FastRide Thru Axle Adapter (100x12 / 120x12) — zdjęcie 1
1 / 3

Thule FastRide Thru Axle Adapter (100x12 / 120x12)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Thru axle adapter (100x12 / 120x12) for Thule FastRide bike rack – easy to print

Ocena
0 / 5
Polubienia
2
Pobrania
11
Wydruki
0
Wyświetlenia
105
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This 3D-printed thru axle adapter is designed for the Thule FastRide bike carrier and supports both 100x12 mm and 120x12 mm thru axles. It provides a secure and stable fit for transporting compatible bikes.

Printing settings:

  • Material: PETG

  • Layer height: 0.2 mm

  • 5 perimeters

  • 7 top layers / 6 bottom layers

  • No supports required

  • 3 mm brim recommended for the connector pieces to ensure proper bed adhesion

The connector pieces are designed for a tight press-fit and should fit snugly when assembled. If needed, they can also be glued in place for a permanent connection.

Important: Do not tighten the adapter to the recommended 5 Nm torque, as this may deform the part and prevent the thru axle from passing through properly.

Disclaimer: Use at your own risk. 3D-printed parts may vary depending on printer settings and material quality.

Note: If you need a different adapter size or a custom version, feel free to contact me.

Good luck :)

Tagi