Led Bar for 2020 profile
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Integrated LED lighting for mounting on a 2020 profile
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 55
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I wanted to make a integrated and original looking led light on my Ender 3 V3 and I didn't like the original one so I came up with this led strip light. My Ender is controlled by a Raspberry Pi, so I used a 24V Led strip with a 3V triggered Mosfet, but you can control and power the way you want to.
Print the parts, (DO NOT insert the led strip in the led strip holder yet!!) insert heat inserts in the T-nuts, insert screws trough the holes in the led strip holder and loosely install T-nuts on them. Install the complete assembly to the 2020 profile by inserting the T-nuts in the rail and tighten the screws. Insert the led strip in the led strip holder and wire it the way you want
Parts needed:
LED strip, 25cm [KLIK]
Heat insert M3 x 4,5 x 4 (3x)
Screws M3 x ~10mm
Spiral cable (2 x 0.3mm2)