1 / 6
40mm rack fan mount for SFP ports, 100º airflow angle — zdjęcie 1
1 / 6

40mm rack fan mount for SFP ports, 100º airflow angle

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

SFP/Transceiver Cooling Mount (Remix)

Ocena
0 / 5
Polubienia
15
Pobrania
85
Wydruki
0
Wyświetlenia
496
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Targeted SFP/Transceiver Cooling Mount (Remix)

Objective

High-performance SFP modules—specifically RJ45 10GbE transceivers—generate significant heat that can lead to thermal throttling or premature hardware failure. This mount is designed to provide active, targeted cooling to the transceiver stack without requiring internal modifications to the switch.

Design Optimization

Unlike standard 90-degree mounts, this part utilizes a 100º mounting angle. This specific geometry "scoops" the air and directs a high-velocity stream directly onto the exposed metal of the SFP modules, effectively bypassing the obstruction of cable connectors and fiber boots.

Hardware Recommendations

For optimal performance, I strongly recommend a 40x20mm fan with high static pressure (rather than a standard 10mm slim fan).

  • Why 20mm? The deeper frame allows for more aggressive blade pitch, which is essential for "punching" air through the high-impedance environment of a dense cable stack.

  • Reference Fan: I used a Sunon MagLev (Vapo Bearing) series fan, which is an excellent choice for its high static pressure and silent operation.

Empirical Results

In a steady-state rack environment with an ambient temperature of 22ºC, this modification achieved the following results on a UniFi 48-Port Pro switch:

  • Baseline Temp (Passive): 60-65ºC

  • Optimized Temp (with mount and 4020 fan): 40-48ºC

  • Average Delta: -15 to -20ºC reduction across all monitored ports.

Printing Notes

I recommend printing in ASA, PC-CF, or PA-CF to ensure the part can withstand the localized heat of the rack environment without warping. For maximum strength, print the part on its side (profile flat on the bed) to ensure continuous filament lines around the "elbow" of the bracket.