Minecraft Chicken Keycap (Wings flap when pressed!)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A minecraft chicken keycap that flaps its wings when pressed!
- Ocena
- 3 / 5
- Polubienia
- 21
- Pobrania
- 140
- Wydruki
- 2
- Wyświetlenia
- 755
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution
A minecraft chicken keycap that flaps its wings when pressed. The base of the keycap holds the wings in place, only allowing them to rotate when the button is pressed as the button drags the wing down with it.
PLEASE PRINT THIS AT A LOW SPEED, THERE ARE 2 VERY THIN 0.5MM WALLS THAT ARE LIKELY TO BEND WHEN PRINTED AT A HIGH SPEED ESPECIALLY ON BED SLINGERS. This project was submitted to a program called construct, and the "FOR CONSTRUCT PRINTERS" file is to be used only by the construct printers (or anyone who wants a bigger and single color model), and the "FOR NORMAL PRINTERS" file is to be used by anyone else.
Assembly instruction:
use the pegs and some glue to attach the mouth to the body, then glue the eyes onto the body, and put the body in the green base, then push the wings through both the main body and the green base holes, and lock it in place by cutting 9.5mm filament (not lower, can be higher although it will look worse) and finally glue on the brown base onto the green base and you're done!