Spool Weight
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Spool weight for low volume spool. Useful when printing from a dryer box.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 58
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
I hit a snag while printing from my dryer box recently. A roll was getting close to the end and was too light to remain upright/stable in the dryer box. It was pulled off center and caused a mess – see last photo.
After googling, it was clear I needed to add weight to my almost empty spools to remain stable. I found a few options/designs out there already, but none quite matched the dimensions I wanted for my dryer spacing and spools from splice3d.com.
I took this opportunity to work on my design skills in tinkercad and learned quite a bit from this one…and probably way over-engineered it. After more time than I care to mention, this is what I turned out and it’s working great for me.
The design will hold 3 stacks of 37 American pennies…plenty of weight.
A retainer disk holds them in place when moving from one spool to the next.
Lastly, there are a couple of tools to help with tightening and loosening the retaining disk and cannister/lid.
Settings for my print:
PLA
.20mm layer height
20% Infill
Supports off