Creality Ender 3 Sunlu Dryer Mount Bracket
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
To mount Sunlu filament dryer for use as spool holder on an Ender3. (May work for other printers with 20 mm cross bar.)
- Ocena
- 4,833 / 5
- Polubienia
- 74
- Pobrania
- 558
- Wydruki
- 6
- Wyświetlenia
- 3721
- Oceny
- 6
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial
Mount the Sunlu filament dryer in place of your out-of-the-box spool on the Creality Ender 3. Designed for the original Ender 3 but should work for other models.
Print 2 brackets - they are identical.
You can use the out-of-the-box bolts and t-nuts for the right hand side bracket. For the left hand side you will need to replace the M5x20mm bolt with longer. (I used 30mm but I think 25mm would have been fine.)
I recommend the use of a filament guide as shown.
The original spool holder can still be used by printing the 2nd bracket that will offset the spool. To mount this you will need M5 screws and t-nuts.