Bass membrane clarinet with evenly spaced holes
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Well known membrane clarinet concept with a twist...
- Ocena
- 5 / 5
- Polubienia
- 18
- Pobrania
- 147
- Wydruki
- 2
- Wyświetlenia
- 1120
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Music
- Licencja
- Creative Commons — Attribution
This build was inspired by Nicolas Bras and his creaton of membrane clarinet with evenly spaced holes.
This is not maybe that precise with tones, but it it based on same scale and tone progression he uses.
For me best worked to just conect male+female attachment as connection for body and membrane part, but for correct tonal should be longer.
Parametric membrane clarinet body tuned around D natural minor / E natural minor fingering, with D2 as the lowest note (all holes closed).
This version is designed to work with a separate membrane module that provides an input pitch of about 160 Hz. The first finger hole starts about 48 mm from the connection to the membrane module, with 20 mm hole spacing and 9 mm finger holes. The body tube uses an inner diameter of 16 mm and an outer diameter of 20 mm.
Open-hole note sequence from left to right: D3, C3, B2, A2, G2, F#2, E2.
Best use thin rubber glove for membrane. All instructions about tunning membrane etc can be seen in Bras's videos :)
Oh and printing, for most parts no support needed. I printed only clarinet body with supports, but maybe even that part could be without it and it was slightly painful to remove tree supporst from inside (around holes).