Racktime Snapit 1.0 70mm adapter plate for Taillight 50mm
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Adapter plate to screw a Supernova TL3 pro Taillight to Racktime Snapit 1.0 70mm mount.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 161
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Hey Folks,
I wanted to have a brakelight on my bike. I decided to choose the Supernova TL3 pro.
Due to the fact that I don't wanted to make some new holes in my bike and I can't replace the previous tail light as it was mounted on the fender, I thought that I could use the holes on my Racktime snapit 1.0 (70mm) cargo rack as I don't use it.
The Problem is that it looks like there is no technical definitions for it out there in comparison to the Snapit2.0 system. Snapit 1.0 could be between 70mm and 120mm wide. In my case it is 70mm which means the holes are around 60mm spaced to each other.
The standard of tail lights is 50mm. So I had to design a adapter Plate for this.
Print instructions:
As it is on the tail of the bike it is very exposed to direct sunlight, I decided to print this in ASA but also ABS and possibly PETG should work. Depending on how often you want to replace it ;)
Nozzle: 0.4
Layer height: 0.20
Support: Yes on the inner holes. You will see it.
Parts needed:
M5x16 Screw 2x
M5x25 Screw 2x
M5 squarenut 2x
Have fun.