Battery Backpack for PiWars Badge
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a backpack for the 2019 PiWars badge created by 4tronix that allows it to be powered off 2xAAA batteries…
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 136
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a backpack for the 2019 PiWars badge created by 4tronix that allows it to be powered off 2xAAA batteries mounted behind it rather than via the USB port, making it much nicer to hang around your neck.
Parts needed:
- Badge (https://shop.4tronix.co.uk/collections/4duino/products/piwars19-badge)
- Edge Connector (https://shop.4tronix.co.uk/collections/4duino/products/breakout-for-piwars-2019-competitor-badge)
- AAA Battery Holder (https://www.proto-pic.co.uk/2xaaa-battery-cage-with-jst-connector-for-bbc-microbit.html)
- 5V Boost Regulator (https://www.proto-pic.co.uk/pololu-5v-step-up-voltage-regulator-u3v12f5.html)
- Power Switch (https://www.proto-pic.co.uk/spdt-mini-power-switch.html)
- Red and black wire
- Head Shrink
- 2x AAA batteries
Thanks go out to Gareth at 4tronix for kindly sharing the board outline of the PiWars badge! Without that this design would have been so much harder to do.
Video: https://www.youtube.com/watch?v=Cjwtb13ZBzw
Edit: Added an alternate version for the newest edge connector that is being sold.
P.S. Included a .step file for anyone who wishes to remix this support additional sensors etc connected to the data pins on the edge connector.
Print Settings
Printer Brand:
Prusa
Printer:
i3 MK2S
Rafts:
No
Supports:
Yes
Resolution:
0.2
Infill:
10%
Filament: SpannerHands, Rigid.ink PLA Pearl Red, White
Notes:
Supports are only needed from the build plate. None are needed for the overhang that hides the edge connector wires.rnrnWith a 0.2mm layer height, a filament change from Pearl Red to White was done on layer 16.2mm.
To wire this up:rn- Solder the red wire of the battery pack to one of the end contacts on the switchrn- Solder a red wire between the middle contact of the switch and VIN of the regulatorrn- Solder another red wire between VOUT of the regulator and the VCC pin on the edge connector (check the badge)rn- Solder a black wire between the GND pin of the edge connector (check the badge) and GND of the regulatorrn- Finally, solder the black wire of the battery pack to the same GND pin of the regulatorrnrnNote the wires from the switch need to be bent 90 degrees once the switch is installed so that the edge connector can be inserted correctly.rn
Category: Electronics