Thin Under Desk Drawer (taped)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Thin Under Desk Drawer which attached to the desk with sticky double sided tape. Size 160x250 mm (enough for A5 paper)
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 60
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution
Simple thin drawer that can be taped under a desk. It is 16 x 25 cm. Enough for A5 paper or small notebooks. Just thick enough for paper clips and small items. Tape should be strong enough given that unless you put gold blocks into it, it shouldn't be too heavy for tape to hold.
Design explanation and consideration
The diamond hole under the drawer is there to reduce filament, and also a finger hole to pull the drawer out because it has no knob. I don't put the knob in because I planned to print in Vase Mode at first, but it doesn't work as well.
I think the drawer can be printed in Vase mode at 1 mm wall, but not necessary. In fact, the fillet might be too steep.
Therefore, the drawer as shown in the photos are printed normally. Drawer printed flat. Frame printed vertically.
The back of the frame, the side that is to be taped to the desk, is designed to be flatted. I've tried two-sided design and the drawer drooped. It then squeeze the drawer and made it difficult to slide. You don't have to tape the whole thing. Just on two sides is enough, but the plastic has to be there for structural purpose.
I print this on my K1 Max. It might be challenging on smaller printers, but you can remix it or scale it to fit your printer.