Maul Shadow Lord Wallmount - NO AMS
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
My second design for a Maul lightsaber wallmount
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 52
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Props
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Holocron themed lightsaber wallmount for Mauls double-bladed lightsaber from Maul Shadow Lord series.
Print Tips: (printed on Flashorge Adventurer 5M with Orca-Slicer)
1. There are three plates for this print and each one has different settings in the 3mf file. They ae also labeled by the color and filament I used.
2. The wallmount has custom painted tree supports to cut down on filament waste.
3. The Maul logo is already oriented correctly to print with the small mounting tabs on the back facing up. The slicer will say that it needs supports but you can ignore that warning.
4. The head is printed in place and needs no supports. I did enable "Apply Gap Fill" for "top and bottom surfaces" and "Filter out tiny gaps" at .3 mm for a smoother finish. I didn't enable Ironing/Top most surfaces because I feel it just takes too long but it couldnt hurt if you want add an additional 45 minutes to the print.
Assembly: It's pretty straight forward after you've printed up the three parts.
A. The head snaps into the top of the holocron. There are cutouts at the top of the holocron that will line up with the chin. It will be a little tight and I did give it a few taps with the side of my pliers to get it in.
B. The Maul logo has three small pegs on the back that line up with holes at the bottom of the holocron. They should just snap in with a bit of pressure. If it needs more force try using a flat object like a hard book on top and tapping it down with the side of your fist.