Sun Visor Repair Clips for Jeep JK
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Repair clips for sun visor to replace torn rubber sleeves on Jeep JK
- Ocena
- 5 / 5
- Polubienia
- 8
- Pobrania
- 55
- Wydruki
- 0
- Wyświetlenia
- 241
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Standard Digital File License
Sun visor replacement clips for when the oem rubber sleeve finally wears out and rips off.
There are two kinds of clips in this 3mf file.
The first pair are slotted for those of you who don't want to wrestle with removing the tiny metal rod from the visor (I didn't). You can use a small pair of channel lock pliers to squeeze the clips onto the metal rod without any kind of dissasembly.
The second pair are unslotted for those of you who do want to remove the tiny metal rod. This pair will just slip onto the rods before you snap them back into the visor.
Print Tips:
I printed this in Sunlu PLA+ 2.0 which is perfectly fine for use here on the East Coast. PLA WILL SOFTEN AND WARP AT HIGH TEMPS! If you live somewhere where the temps inside your car can reach close to 120-130 F (50-54 C) then I recommend using PETG or some other filament with higher heat tolerance.
Sunlu - Black - PLA+ 2.0
Layer Height: 2
Infill: 50% - Concentric
Outer Brim Only: .3 mm
Print Time: 18 min
*If using the 3mf file just load your filament and hit print, these settings are already loaded per object.