M3 screw widener
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Makes the screw head wider without costing a lot.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 2
- Wydruki
- 0
- Wyświetlenia
- 40
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is for m3 socket head screws if you need a small little bit to make the screw a bit wider in my case it was for a final project for a micro-controllers class to mount a LIDAR sensor. Go crazy with it I don't expect it to be really useful lol.
This takes any size M3 socket cap screw really I've not tested every one but I'm 99% sure it works with every M3 screw.
Recommended print settings are 3 wall 10% infill and a 5mm outer brim. It might possibly pull off on the bottom but it shouldn't be too much of a filament cost. Here is the recommended print orientation shown above.
Change log:
4/29/2026 Added second file for the lidar sensor to make screwing on the screw into the locking nut mechanism easier