Support / Stabilizer for Prusa Enclosure MK4/MK4S - Modification
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A medication of an existing spacer to stabilize MK4 against the enclosure roof
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 159
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- GNU General Public License v3.0
This is a support to stabilize the Prusa MK4 / MK4S printer inside the original Prusa Enclosure. It helps to prevent the printer from shaking or wobbling.
The supports are placed on the upper frame and push against the top of the enclosure to reduce vibrations. To install them, you need to open the enclosure lid.
After printing the stabilizer, there is a gap between the support and the lid. You can fill this gap with a piece of felt or rubber tape. It should be 2–3mm thick and no larger than 40mm x 40mm. This prevents slipping and adds a little bit of pressure for better stability.
I recommend printing this with PETG. I used 4 wall lines (perimeters) and 25% infill. This makes the support very strong and stable
I have included the original Fusion (*.f3d) file, so you can adjust the support if needed.