Dehydrator Spacer for Drying Filament Outdoor Gourmet
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is an adapter that makes this dehydrator able to hold spools for drying at high temp.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 63
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Public Domain
I was looking for a dehydrator that would reach 70C (158F) that was larger than other dryers. I considered a specific 3d print dryer but most of them only hold one roll and reach 65C. I have been wanting to print ABS and with my AMS Pro 2 only reaching 65C, i needed something else. I know 3D printing is not the hobby for it but i really hate ordering things online, i like to be able to buy them local. I think i tend to end up with better products for regular stuff like a basic kitchen appliance. I found this digital food dehydrator that goes to 70C, will run for 12 hours and only required some minor changes. I also plan to design an even taller spacer so that you could stack 2 or even 3 rolls of filament in at a time. I purchased this one at Academy Sport of all places and it was $55 but i am sure they are mostly generic branded, the tray is 321mm diameter.
Print settings - ABS or PETG is your best option because of the heat it will be exposed to over time, 100% infill since they are so thin, print with a brim to prevent lifting, layer lines don't really matter, i used .16. Uses about 123g.
The spacer is just 1/4 of it and it is printed 4 times, all can be done on the same plate. I used hot staples to attach, i am sure glue would work but it would be awkward to clamp. I use the Pittsburgh hot stapler 70770. The tray that comes with the dehydrator has a 7-8mm lip on the inside to prevent food falling into the middle. YOU MUST cut that part out and make it flat on the inside or the filament roll won't fit.