HotWheels 4-Post Lift
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Vehicles
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The model could be printed as one hole batch, i designed it to be glued together or not, so do as you wish.
I printed it with a Brim of 2 mm for preventing warp on the sharp corners.
It does not requires supports as the holes could be printed facing upwards from the bed.
I used PETG but i think it would work perfectly with PLA.
The 3mf that I upload carry the configuration of prusaslicer I used, if its required change it!
Note: It is a bit dificult to fit in the pilars and the upper base, i used a dremel to made the holes a little bit bigger and cut the fit in pices and it matches the build.
I hope to see your makes and the suggestions about the design, feel free to remix it.