Logitech G29 Mainboard Enclosure with Pedals and Shifter Ports

This enclosure is designed to house the Logitech G29 mainboard and provide clean, protected access to the pedal and shifter connections. It offers a compact and organized solution for projects where the original wheel housing is not used, such as custom simulator builds or standalone controller setups.

The case includes dedicated openings for the pedal and shifter connectors, allowing convenient cable routing while keeping the electronics protected from dust and accidental contact. The design focuses on straightforward assembly and reliable mounting of the board inside the enclosure.

All screw threads are directly modeled into the part and are designed for M3x5 screws with a 0.5 mm thread pitch. This allows direct installation without the need for threaded inserts. For best results and long-term durability, careful tightening of screws is recommended to avoid damaging the printed threads.

Printing instructions:
Print the enclosure with the flat base facing the build plate. Supports are typically only required for connector openings, depending on your printer capabilities. A layer height of 0.1 mm or finer is recommended to ensure accurate thread formation. Use at least 3 perimeters.

Hardware required:

• M3x5 screws with 0.5 mm pitch

• Logitech G29 mainboard

• Pedal or/and shifter compatible with the G29 system

This enclosure is suitable for custom simulator projects, hardware modifications, or standalone controller setups where the Logitech G29 electronics need a safe and practical housing.