Low-profile DB-15 (VGA) bracket — replacement for narrow PC case

Lost the short bracket from your graphics card? This model will help you replace it.

This bracket is designed to mount a DB-15 (VGA) connector to the rear panel of a narrow (low-profile / slim / SFF) computer case. It occupies exactly one slot and is perfect for older graphics cards with an external VGA ribbon cable.

Important note: Keep in mind that you will still need the main bracket that attaches directly to the graphics card. This model only acts as an adapter bracket to route the connector to the case.

The model has increased thickness — this is done to achieve the necessary rigidity when printing and during use. However, because of this, you may encounter installation issues in the standard slot of your case. Be prepared to manually modify the design with hand tools (a file, hobby knife, or fine sandpaper) to fit your specific case.

📁 What's included:

The file contains a print profile created in Bambu Studio. It is fully configured for the best print quality for this geometry.

⚠ Important recommendations:

Print speed: Be careful — you may need to reduce the print speed for your printer (especially on small details).

Supports: It is recommended to increase the support density if your printer tends to leave stringing around the connector hole.

Material: PETG or ABS are preferred over PLA.

Mounting: The bracket is secured with a standard case screw (screw not included).

🛠 Required post-processing:

The DB-15 hole may need slight adjustment (especially if your connector has a shielded housing).

The side edges may require light sanding if the bracket fits too tightly into the case slot.