Arduino UNO R4 WiFi Case with Shield
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Arduino R4 Case
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 20
- Wydruki
- 0
- Wyświetlenia
- 168
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial
Arduino UNO R4 Protective Case with Shield Clearance & Snap‑Fit Mounting
Overview
This enclosure is purpose‑built for the Arduino UNO R4 (WiFi or Minima) and provides full vertical clearance for an attached shield, plus a secure snap‑fit base and a removable cover. The design keeps the board protected while still allowing access to all ports, headers, and mounting points.
1. Prepare the Case
Place the empty case on a flat surface. For easiest installation, set a small object underneath the center of where the UNO mounts into the case — a socket, bottle cap, or small block works well. This gives you something to press against when flexing the bottom panel.
2. Insert the UNO R4
Place the UNO as far to the right of the case as you can, the power port will sit against the wall.
Press downward with one hand on the upper and lower parementer of the case. This will will cause the floor of the case to bow upwards slightly and open up the tabs that hold the UNO in place.
Press down on the UNO andl you feel the board snap into the upper and lower tabs.
3. Slide the Board to the Right
Once snapped in, slide the UNO R4 to the right. This aligns the barrel power jack with the dedicated cutout in the case wall. You’ll feel it settle into place when the port is fully seated.
4. Install the Shield (Optional)
If using a shield, plug it onto the UNO now. The enclosure provides enough vertical clearance for standard shields.
5. Attach the Cover
Place the cover on top and gently press it into position.