Bambu X1C / P1S / P1 Hotend Stealthburner Printhead Press Fit Only + Wire Clearance
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simplified version of the Bambu to Stealth burner mount. No bolts, just the press fit and added cable clearance.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 28
- Wydruki
- 0
- Wyświetlenia
- 307
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- GNU General Public License v3.0
2026-09-17 - Update: Added modeled in support for the back side. Added a front side without Bambu text. Added a full STEP assembly including the hot end.
This adapter does not need the difficult to install heat set inserts. It also removes material that can be used for cable clearance so I did away with the redundant mounting holes and added cable clearance and a pathway to snake the thermistor and heater wires out on the right side.
The press fit is plenty, it does not need any fasteners. This setup is rigid and simple to assemble now. Finally a reliable and affordable source for decent hot ends and nozzles that do not leak. I can now swap nozzles quickly on the stealth burner by removing the 4 front bolts and swapping the assembly!
ASA prints with the .4mm and .6mm nozzles came out perfect.
12mm^3/sec flow rate max at 270C with polymaker asa on the .4mm nozzle.
19mm^3/sec flow rate max at 270C with coex asa prime on the .6mm nozzle.
The flow rates don't sound impressive, but I find them reasonable without spending a fortune.