Xiegu G90 Mobile Mount Box

A mobile mount for the g90. 

You will need a universal radio mount bracket and 4 1/4x20 or equivalent threaded inserts with 1/4 x 20 x 1/2" screws to mount.

I printed this with 40% infill using tree supports and it should print fine with minimal post cleanup.

Assembly: You will need to temporarily remove the rear side brackets and rubber feet on the back of the g90 so it will slide up onto the transceiver. it will fit with some slip and I used a small section of foam tape on the edge to make it tight but even with noting it holds pretty well.

I began this model modeling the fins but it never really worked well so I simply made the sides a smooth cutout instead.

I made the holes offset to angle the radio so you can choose if you mount it overhead as I did and angle it down, or if lower you can mount it angled up or simply only use the center hole and tighten it to make it adjustable angle.

thank you as always and enjoy your radio and happy printing!!