TF2 Rocker Launcher (Nerf blaster mod from Dalardans' Woose)

If you want to buy me a coffee :) https://buymeacoffee.com/methanejuice

Shoots like a pump action, front-loading, like in-game

Uses MXL, Nerf arrow, or Stomp rockets

BOM: 

1. Dash 016 Oring (9452K) QTY 5

2. Small Bearing (57155K541) QTY 4

3. M3X10mm (92095A182) QTY 4

4. 0.527 x 6in barrel QTY 4

5. Ball Detent 6x7mm QTY 3

6. Compression Spring 23/64" x 1-3/8" (got from this kit) QTY 1

7. Small OD elastic core

8. Larger OD elastic core (consult Woose spec)

9. Glue

Filament usage (Caution, a lot)

Mind the orientation for structural integrity 

Assembly Guide: 

1. Grip assembly: The pins should Grip Pin qty 2, glue not needed

   

1. Assamble Catch_Housing, Catch, Catch_Hinge1&2, Catch_Arm, Catch_Pin1. Lube the two durfaces. Thread the elastic cord (4mm OD or similar) through the green path and tie knots at the circled spots. Do not put too much tension

1. Placed in the Rocket_Tensioning_R&L piece, add the Catch_Pin2 

1. Secure using Rocket_Tensioning_Pin 1-1&2

1. Lock down using Rocket_Tensioning_M

   

1.  Assemble the grip, catch with Barrel_L2_R and Barrel_L3_R, placed in these Common Joints, and secure with Common Joint_Pin1s in blue locations, Common Joint_Pin2s in pink. Stock Pin 3s in green, Stock Pin 2s in red, Trigger_Pin2 in purple

   

   

1. Install the Trigger cover Grip Pins

   

1. Install the other half of, plus pins

   

2. Install roller and its pins

   

1. Glue on the Rocket_Tensioning_Core and Rocket_Tensioning_B

1. Install the plunger the same as the Woose

1. Drop in the body as such, lube if there too much friction

1. Rout the larter od cord like so, tied in the back circle red

   

1. Add in qty 2 ball detent

   

1. Install the bearings with M3 screws (two on each Barrel_L1 pieces)

   

1. Install Rotor Frame R, IndexPusher, a ball detent, and the compression spring

1. Install the Breach, Rotor Shaft, Rotor, and Rotor center

   

1. Depending on the ammo type you use, install the different spigots. To launch Stamp Rockets and Nerf arrows, I use the 0.527 barrels with O-rings. To launch MXL use the MXLspigots

   

1. Close the two halves with Rotor Frame L, the Common Joints, and safty tip

   

1. Glue the O-ring on the tip of the PT Grip, push down the front asm of the launcher with the joints installed 

   

1. Lock everything down with the remaining pins

   

1. Install the front grip with its pin

   

1. Glue all the shield pieces together

   

1. Assemble the back pieces with their pins. 

   

When operating the launcher, don't put your thumb at the back of the front grip