Square lens hood for Mandler LTM lens on Barnack Leica
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a square lens hood which sits correctly on the Mandler 35mm LTM lens, on my Barnack Leica cameras.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 28
- Wydruki
- 0
- Wyświetlenia
- 215
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution — Noncommercial
This is hood is for the Mandler 1:2/35 LTM version lens, for a specific use case. When attached to my Barnack Leicas the indexation mark of the lens is rotated about 10 degrees clockwise so square hoods sit at an angle. This was noted by Mandler and they do not sell such a hood for the LTM version. I have observed an offset of about 10 degrees on multiple Barnacks and M adapters from Voigtlander and Mandler themselves. Your camera may differ however.
Pre-WWII Barnacks seem to be more variable in offset, so you may want to adjust for your camera by slicing the mount off and rotating it.
The hood is push on (I may develop that further in future) and I have printed it with PLA and ABS. One of the indexation lugs has a small groove to allow paint infill.
The cap should Ideally be printed in TPU 95a as it allows it to be “peeled” off without pulling the hood off the lens. There are two versions, one with the Mandler logo and one without. I will happily remove the logo version if requested by Mandler.
This hood is a fairly heavy remix of “Leica style Lens Hood” by Donii (https://www.printables.com/model/610486-leica-style-lens-hood), which in itself is a remix of “LEICA style lens hood for fujifilm XF23 XF35 f2” by Chen Felix (https://www.printables.com/model/372956-leica-style-lens-hood-for-fujifilm-xf23-xf35-f2).
This is my first posting so I hope I have I have given all the credit I should.
