Dewalt Grabo lifters DCE592B vacuum clamping system REMIX
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Total credit goes to LUMA’s project, This remix creates a universal base for the grabo, not limited by print bed size.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 180
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Garage
- Licencja
- Creative Commons — Attribution — Share Alike
Dewalt Grabo lifters DCE592B vacuum clamping system REMIX
Total credit goes to
DDD Dewalt Grabo lifters DCE592B vacuum clamping system by luma | Download free STL model | Printables.com by LUMA
Restriction by Luma’s project is you need to print a full base for the grabo.
So I looked at designing a universal base for the grabo, not limited by print bed size. Made a threaded end-and-air-tube-insert, to mount onto a piece of 3 / 4 inch plywood. Actually took 1 / 2 inch plywood, sandwiched it together, so I had enough height. Polyurethaned the top.
Made air-fitting-and-air-tube-insert, I cut out the plywood, to fit this, I clamped it so the top surface was down against a flat board, siliconed the attachment into the board.
Then screwed it in. the board has ok suction (got to about 10 psi), but I added an ikea cutting mat on top, and this gets suction to about 11.
THIS IS A WORK IN PROGRESS, and i will refine it later. But for those of you who are mechanically inclined, you get the idea, you now are not restricted by bed size, for a grabo base. The base can be used for any grabo, just size it accordingly.
Also, for the vacuum blocks, I wanted a gasket, instead of the foam. (why, just bexcuase…. 😊 ) so I started working on how to deskign a gasket. Gasket is a solid infill design in fusion, but in bambu, made it hollow zero infill, thinned out the top,and it works. The gasket needs to be siliconed to the vacuum block, because the textured bottom surface of the gasket (printer bed) allws some air to get in. but when siliconed, and used, it works similarly to the foam.
Also, I made vacuum block with TWO holes,. I made a TPU plug for the bottom hole, if I don’t need the bottom hole, but that is not working totally efficiently, still working on it.
But, I could have suction top and bottom, for a table where there is no holes for mounting, so bottom suction coult hold to base, and top suction could hold object to be worked on.
AGAIN, WORK IN PROGRESS, and any feedback or suggestoins are appreciated, for this project. Also, how to make the air connections more efficient, as slight leakage.
Again, thanks to LUMA, and hope this is of interest to others.