E-stop enclosure for 3D printer
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Uses M3-10mm thread-forming screws, a 19MM momentary push button switch, & #8 x 1-1/4" flathead woodscrews for mounting.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 3
- Wydruki
- 0
- Wyświetlenia
- 24
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial
Uses M3-10mm thread-forming screws (https://www.amazon.com/Stainless-Rolling-Plastic-Passivated-Phillips/dp/B00GDYD040), a 19MM momentary push button switch (https://www.amazon.com/dp/B08BKRX6X3), and #8 x 1-1/4" flathead woodscrews for mounting (https://www.amazon.com/LIONMAX-Exterior-Outdoor-Resistant-Included/dp/B09KRNZ32K).
The M12 x 1.5mm thread has a 4° taper so that the nut compresses the wire ~.4mm radially in each direction (.8mm total compression) to ensure that the cable doesn't pull out.
NOTE: no supports should be used except for the enclosure base part (for the wire grommet hole). All other parts should be printed in place without supports.