PB Swiss Hex Driver Holder/Stand
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A stand/holder for four PB Swiss hex drivers.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 4
- Wydruki
- 0
- Wyświetlenia
- 29
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution
Many Apologies: I had originally posted incorrect model files (from an early revision). These have an overhang at the top of the bottom part of the clip that would likely require support when printing. The correct version of the model files are now been posted. If you downloaded any files before 2026-05-07, you will likely want to discard those. |
This is a redesign from scratch of the Wera Micro Stand by demek. It's the same basic design, but modified in order to fit the larger PB Swiss drivers.
This is designed specifically to fit the PB 8625 four-piece hex driver set, though it may fit other PB Swiss drivers as well.
I printed it on a Prusa XL (though it should fit in most printers):
Jessie PLA
0.4 mm nozzle, 0.2 mm layer height
Four perimeters
15% adaptive cubic infill
It's designed to print upside-down without supports.
Note that the model files posted here do not include the 大力 lettering visible in the photo.