1 / 2
Lapidary Dop Holder for Graves and other 1/4" dops (OpenSCAD customizable) — zdjęcie 1
1 / 2

Lapidary Dop Holder for Graves and other 1/4" dops (OpenSCAD customizable)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Stand organizer for lapidary dops. OpenSCAD source file included.

Ocena
0 / 5
Polubienia
2
Pobrania
19
Wydruki
0
Wyświetlenia
82
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Organizers
Licencja
Creative Commons — Attribution — Share Alike

This is a handy holder for lapidary dops, or any other stick-like object of consistent diameter which you would like to hold vertically.

Models are provided for 0.25 inch and 6 mm dops. Start by printing the test standard fit file for your dop size; then, choose standard or looser fit based on your printer and preference.

Printing instructions

I used PLA at 0.25 layer height, but pretty much anything should work. For a correct fit, make sure the seams are placed in the corners of the teardrop holes. The slicer will usually do this automatically, if you don't have seam placement set to random.

Customization

If you'd like a file with more or fewer sockets, or larger/smaller sockets, leave a comment OR you can use the OpenSCAD source file to generate your own. The OpenSCAD source file requires the BOSL2 library. All of the settings you need are most likely available in the Customizer window.

Tagi