Updated Base For Libre Computer Case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I printed this case for my Libre ALL-H3-CC SBC computer board, and while it fit (almost) perfectly, I needed some…
- Ocena
- 5 / 5
- Polubienia
- 5
- Pobrania
- 66
- Wydruki
- 2
- Wyświetlenia
- 755
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I printed this case for my Libre ALL-H3-CC SBC computer board, and while it fit (almost) perfectly, I needed some mounting tabs to secure it to the wall. Hence, mounting tabs with which to secure it to the wall.
v1 is the one that I initially modeled and printed, only to realize that, in an effort to keep the ears symmetrical, I had inadvertently placed one if them directly below the power connector. Had I been using countersunk screws, I don't think that would have been a problem, but to avoid potential issues for others, I moved that one ear over slightly in v2.
I have only provided the modified lower half (without the GPIO cutout) here. You'll have to get the top half from the original post by luc4r4t0r.
Another Sketchup Model - Debunking the Myth that Sketchup is Useless in 3D Printing
Print Settings
Printer Brand:
TEVO
Printer:
Tarantula
Supports:
No
Resolution:
0.2mm
Infill:
40%
Category: Computer