ROOK Runner Frame - Printable Jointed Figure (Dummy 13)

"Preparing scavenger protocol... R O O K  O N L I N E"

A ROOK frame is a scavenger's best friend. These base robotic frames are typically utilized by the UESC and various corporations for manual and heavy labor. RUNNERS have taken to augmenting these simple frames to house a limited-use neural sync adapter allowing the RUNNER to inhabit the ROOK for short periods without too much mental degradation. Because they are not SHELLS, each ROOK has only a small set of kit-bashed ABILITIES and fully lack the functionality to be upgraded via IMPLANTS and CORES. Though some variety of standard system upgrading can be achieved, a ROOK will never match the full complement of ABILITIES, comfort, and general utility inherent in more advanced bio-cybernetic SHELLS.

Rook Strong Together.

Based on the Rook runner shell from Marathon, now you can print your own scavenged kit-bashed bot. Built from repurposed UESC parts, this simple frame was modeled with the Dummy 13 figure as the base, with many Dummy 13 accessories available to mix and match with.  

At 100% scale, the Rook stands at about 6 inches tall. If you wanted it to be to the same scale as my Recon & Thief figure, you would have to scale the Rook down to 90%, but note that any Dummy 13 accessories would need to be scaled down as well. 

I followed the Dummy 13 recommended print settings, and enabled supports as some parts will need it.

• Layer height: 0.15mm

• Infill: 20%

• Supports: Normal (auto)

• Brim: only as needed

• Perimeter (heh) generator: Arachne (heh)

You can follow the general assembly instructions here: Dummy 13 Assembly Instructions

See you on Tau Ceti, runner. 

© Bungie, Inc. All rights reserved. Marathon, the Marathon Logo, Bungie and the Bungie logo are among the trademarks of Bungie, Inc.