2DIN ADAPTER FORD MUSTANG S197
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
2DIN radio adapter for atleast 2005-2009 ford mustang, Could fit F150 as well.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 19
- Wydruki
- 0
- Wyświetlenia
- 192
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial
Since no one has made one yet, here's a 2DIN radio adapter / mount for my 2005 Ford Mustang GT to swap the factory Shaker 500 unit for an aftermarket touchscreen one. Screws in to original bolt holes and fits a 2din shroud. I believe it also fits to some Ford F150 models. Felt dumb paying 30€ for a piece of plastic, so I made my own! Following the pattern of my other models, this is probably quite over engineered as well, but it works flawlessly! There's a bit of a gap on top, but that doesn't bother me :)
Designed to be printed in one piece with Creality K1C. Just rotate the model 45 degrees and it should fit a 220mmx220mm bed!
Printed with 25% infill, and a wall count of 3. Use supports for the mounts. I used normal PLA, but I recommend using PETG, ABS, ASA etc. to prevent warping inside the dash.
If you'd like to show some appreciation, this model is also listed at cults3d for sale :)
https://cults3d.com/en/3d-model/gadget/2din-adapter-ford-mustang-s197