1 / 5
Tiffin Motorhome basement grommets and filler plugs for water line and electric cord — zdjęcie 1
1 / 5

Tiffin Motorhome basement grommets and filler plugs for water line and electric cord

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This basement grommet relaces the rubber seals that tiffin installs in the channels of the water and electric bays.

Ocena
0 / 5
Polubienia
2
Pobrania
6
Wydruki
0
Wyświetlenia
44
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Automotive
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This design was inspired by the Tiffin RV Basement Grommet designed by dnl42. His model was too narrow to fit the channel on my 2025 Tiffin Allegro Bus which is 48MM. Since i was redesigning the grommet I added the capability to have a hole that fits the line going thru the grommet to make sure that critters could not get in when hooked up to utilities.

The water line grommet is sized for a 3/4" diameter hose and the electric grommet is sized for a 1" cord.

Due to its design, the grommet needs to be printed out of TPU so that it can be stretched to flex over the edges of the channel. 

I printed the grommet at a 45-degree angle with the back top corner on the build plate. I put some thin supports on the back side to support the build during printing. The plugs and hanger can be printed from PLA or PETG. 

Installing the grommet took some effort as it has to be stretched over the metal flange. On one, I hooked the bottom of the grommet to the flange and the had to stretch the top of the back over the top of the metal channel. On the other one I put the top in first and then had to stretch the bottom corners over the metal corners at the bottom of the channel.

If the grommet is printed from a rigid filament the flange of the grommet at the bottom would need to be removed to enable it to be installed.

Tagi