Modified Body for 12Hr Rotary Clock - Change viewing angle
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I very much enjoy the rotary clock, but I wanted some adjustability on the viewing angle
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 2
- Wydruki
- 0
- Wyświetlenia
- 12
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I very much enjoy the rotary clock, but I wanted some adjustability on the viewing angle. I redesigned the body so that you can rotate the viewing angle a limited number of degrees. I have not fully tested this at all possible angles (it allows up to 30 deg in each direction from standard) but the prototype running on my desk is locating/indexing the clock wheels just fine with it angled up about 20 deg. No software change is needed.
I made this by redesigning part of the body, and then "joining" it with part of the original design (the part the holds the wheels) in Tinkercad. I've included both my design and the joined part. The design has a trapped rotating mechanism. Depending on the accuracy of your printer, it may fuse together while printing (not good). If so, try rapping on the part with the handle of a screwdriver to break it free.
This is a work in progress. I think I can condense the design to make it less thick, and cleanup the design a bit, maybe hide the seam you see when looking at the time.
(Yes. I did a terrible job painting the numbers. I'll try harder next time. Shiura, maybe you can make us one with separately printed number segments that we can glue on :-)