Copper Pipe Brush for compression fittings
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Split up a plumbing tool into 4 useful pieces, instead of one awkward one
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 25
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I needed to install a compression fitting on a new copper stub-out at a sink. The copper tube was discolored and had gotten paint slopped on it, so I needed a copper tube brush to clean it up for the fitting. I bought one of those all-in-one tools at HD that has the 1/2 and 3/4 inch, inside and outside wire brushes on it. That was a mistake.
Because there were two stub-outs and a drain line all fairly close to each other, there was no way to rotate that long 4-in-1 tool. So I cut the tool in half and was able to finish the job.
Once done, I decided I'd like it even better if I separated the inside and outside brushes (so the inside-the-pipe brush would not poke me while using the outside cleaning tool). Thus I needed to design and print a housings for the outside brushes. That's what this thingi is.
Printed in regular PLA, about 25% infill, 3 wall lines. The cap will snap into the main housing with a little force, or maybe scrape just a bit off of one side of the cap so it goes in easier