FW-190 Spinner for Hobbyking
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A replacement spinner for the FW-190 for a 3 bladed prop
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 85
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I started with rcKeith's spinner (thanks!), then stretched and modified it so it would work with a Windsor 12 x 6 x 3 three-bladed prop. I've flown this and it works well.
This is designed to work with the original FW-190 motor (skinny/long motor shaft), the original spinner base, and the original attachment screw. I also made a spacer that fits over the hex protrusion on the spinner base, so the Windsor prop has a flat surface to press against.
To make the spacer fit perfect on the spinner base hex, heat it with hairdryer until it's a bit soft, and press it on.
To get the spinner to fit in the base slots, I had to slice it at 98% size in the X and Y direction. YMMV on that. Print with supports. I did 50% infill on the spacer and 100% on the spinner.