Bike Headset Cap Water Bottle Cage Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An alternate way to mount a water bottle cage on a bike
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 3
- Wydruki
- 0
- Wyświetlenia
- 44
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
An alternate way to mount a water bottle cage on a bike UPDATE: V2R2 also broke, and it was rotating, which was annoying. So, I did another, stronger one with a tab that notches into the clamp, to prevent it from rotating. So far works great, but it may be specific to that bike's dimensions. In any case, if you want to try it. BikeHeadsetCageMountV2R4.stl
UPDATE: The original design cracked after some use, so I designed a beefier version. I recommend you try that one instead. BikeHeadsetCageMountV2R2.stl
My wife's mountain bike frame didn't come from the factory with any water bottle cage threaded bosses, and all of the other likely locations for mounting a cage wouldn't work for various reasons. So I made this mount that replaces the headset cap.
Important: This HAS been installed on a bike and ridden around a little bit. It seems like it might work OK, but it has NOT been rigorously tested. Therefore, I can't speak to how well it will hold up. If you make one and it breaks (or doesn't), please leave a comment.
The bottle cage mounting holes are not threaded. I let the standard 5mm mounting bolts self tap into it, and it seems to be holding really well for now. If the bolts don't stay tight, back it with a nut and put a little locktite on the threads.
Notes:
I just guessed on the infill. I couldn't see a way to avoid supports. Cleanup wasn't too bad. The STL prints fine in the default orientation, however for the photographed part, I re-orientated it a few degrees so the cage mounting surface was horizontal.