Creality Ender Enclosure Bowden Tube Conduit
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Allows for routing a PTFE tube from outside to inside of a Creality Ender enclosure (or any other fabric enclosure)
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 35
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
This is a very simple little model which allows for routing a PTFE tube ("bowden tube") from the outside to the inside of a Creality Ender enclosure, or any other fabric enclosure for that matter. A use case I have found for this is to have my filament dryer outside of the enclosure to save space, while still being able to route the PTFE tube carrying the filament into the enclosure without introducing air leaks.
Required parts:
4x M2x6 (or longer) screws
4x M2 bolts
Installation:
Place part up against the enclosure where you'd like to install the conduit and mark with the centre hole
Use a sharp knife or scissors to poke through the enclosure before widening the hole to accommodate part A's centre tube
Push part A's centre tube all the way through and mark the four screw holes similarly to step 1
Use another sharp or pointed object to punch the four screw holes through the enclosure
Push part A all the way through and then push part B on top of part A
Secure the 4 screws