Dock-Style magnetic Charging Cases for Wio Tracker L1
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Adds a magnetic Charging port to the bottom of the Wio Tracker case. Includes a solar and usb-c docking station
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 214
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution — Share Alike
This design is a remix of the official Wio Tracker case, enhanced with a two-pin magnetic connector integrated into the bottom, along with a dedicated dock for solar charging. With these additions, the device can operate fully off-grid—no wall outlet required.
The magnetic connector should be glued into place to prevent it from being accidentally pushed inward. It is recommended to install the version without pogo pins directly into the tracker case, ensuring that no pins protrude from the side. The connector can then be wired to the internal solar input on the main PCB.
For the dock, there are currently two configuration options: a USB version and a solar version. To assemble either, print the “Top” component and pair it with either “Bottom_USB_back” or “Bottom_Solar.” The solar variant is designed to fit a 100 × 100 mm, 5V / 3W solar panel, which provides sufficient power for the Wio Tracker. If you chose the USB version you can use these USB connectors. Ensure you get the 6 pin version because they feature the 7.5k CC1 and CC2 pulldown resistors to tell the usb charger to output power. Connect the panel or the USB conenctor to the magnetic connector in the opposing half of the case, ensuring correct polarity.
To secure the dock, insert four M3 threaded inserts into the designated holes in the top part. “Ruthex M3s” inserts were used in this design.