Air Rifle target and scope setting guide with target template.
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Frame and stand for an air rifle paper/card target
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 24
- Wydruki
- 0
- Wyświetlenia
- 177
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial
I generated this frame and stand for card targets. The target slides into the frame which in turn sits into the stand. For added stability weights can and should be added to the base plate of the stand. There is more than sufficient clearance to add into the space a UK size house brick which would keep the stand position stable under pellet strikes. The flat base of the stand could also be secured onto a wall or post to provide a fixed elevation.
The target can be used for practice or to set/adjust the scope. A template (card copy) is included for the targets, ideally printed onto A4 1mm card and cut to size. A sample target from our air rifle recalibration included. 3 shot pattern then 3 additional shots to centre the scope at 20m.
Printing:
Frame PLA 0.16mm layer stood upright on the base plate. Solid fill. No supports. 10mm brim with 0.2mm gap for ease of removal.
Stand PLA 0.16mm layer. 25% infill. Normal support under top bar, 0.25mm top gap, 0.2mm bottom gap.
Both parts on one plate, print time approx 4hrs.