GunplaMark FS2026 4.0L cereal box remix
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I remixed the FS2026 design to fit the 4.0L cereal box from Temu, and also added other improvements from remixes i liked
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 45
- Wydruki
- 0
- Wyświetlenia
- 688
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- GNU General Public License v2.0
I really liked the Filament Storage 2026 solution by GunplaMark, and I’m a big fan of his work.
However, living in Europe means the cereal container he uses isn’t commonly available here.
So I set out to find alternatives that are easier to source via AliExpress and Temu.
I found a 6-pack of 4L containers with roughly the same dimensions and started this remix to fit them.
Because the dimensions are so similar, spools fit snugly inside the container, reducing the amount of air that needs to be dried with desiccant.
Highlights
Body can be printed in one piece on a 220 × 220 mm print bed
Original lid gasket can be reused
Sliding desiccant bin (includes bin and bin holders)
Print Settings (PLA, 0.4 mm nozzle)
Material: PLA
Nozzle: 0.4 mm
Layer height: 0.20 mm (0.24 mm is OK for faster prints)
Walls / perimeters: 3–4
Top/Bottom layers: 3–5
Infill: 15–30% (Gyroid or Grid)
Supports: Only if needed (try “from build plate only”)
Important Notice
The cereal containers I used require a small modification. Due to an indent in the box, some spools may rub against it. This indent can be corrected by carefully applying heat with a hot air gun and pushing it outward.
While this is not a difficult task, it’s something to consider before purchasing the containers.
Used 4L Cereal Boxes