Temtop Air Quality Monitor Magnetic Stand & Cradle
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Stand and Detachable Magnetic Cradle for Temtop Series Air Quality Monitor
- Ocena
- 5 / 5
- Polubienia
- 1
- Pobrania
- 7
- Wydruki
- 1
- Wyświetlenia
- 35
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a stand with a detachable magnetic cradle for the Temptop air quality monitor series. The Temptop is great but it's tall and narrow with a small flip out stand, so it always falls over. This allows you to place it on a table or any flat surface, but also the cradle detaches and allows you to magnetically attach it to metal (ferrous) surfaces.
The stand uses 5 8mmx3mm magnets, and the cradle uses 7 8mmx3mm magnets to give it more holding power on metal surfaces. The magnets push fit in with a fair bit of force, so they aren't likely to come out, but I suggest a bit of superglue just to be safe. There's room for the charging cord to be plugged into the Temptop when it's in both the cradle and on the stand, so it is good as a charging station as well. The supports inside the holes for the magnets can easily be removed if you jam a pick in them and lever them out. I'd suggest printing in PETG, ABS, ASA or something similar for some heat resistance, but if you use it exclusively inside PLA should be fine.